 |
 |
Close Mount
Assembly
- Remove mounting bracket from mounting cone. Leave the screws in the
bracket that match up with the open hole on each side of mounting cone.
- Attach mounting bracket to junction box or directly to ceiling using
screws taped to mounting bracket. Lead wires through
center hole.
- Turn assembly over. Remove retaining knob and clip from bag
found
inside hub.
Rub the motor shaft with soap or light oil. It will allow the hub to slide on easier.
- Align the hub with the motor shaft. Be sure the flat side of the motor
shaft matches up
with flat side of the hole. Press hub on to shaft until
3/8" (1 cm)
of the motor shaft protrudes from the hub. Tighten set
screw.
- Push retaining clip onto motor shaft unit until it is firmly against the
hub.
- Push retaining knob onto motor shaft until it is firmly against hub.
- Lift completed motor and hub assembly to mounting bracket on
ceiling, and slip one hole on side of mounting
cone over hook on bracket.
- With motor and hub assembly hanging from hook, connect
fan
wires to the
house wires using the two (2) wire nuts included with
fan. Red wire is positive +; Black wire is
negative -.
- After wires are connected, remove fan from hook, and slip mounting
cone over
mounting bracket. Align the open holes of cone with the two
screws, and rotate
until cone will stay in place. Then replace the other
two screws in
cone and tighten all four screws firmly.
- .Turn on power, check that fan is working, turn power off.
- .Assemble blade arm and fan blades using the 15 screws and
washers
that are in bag with blade arms.
- .Once the blades and and arms are assembled, attach the assemblies to the hub using the bag of 10 screws found in the hub. The inside hole pattern on the hub is for four (4) blades. The outside hole pattern is for five (5) blades.
Any questions or comments, contact RCH Fan Works
1-800-529-6306 or e-mail: info@fanworks.com